Open the electrical box using a large flathead screwdriver.
Install the solid state relay in between the end cap and the rightmost connection on the rail, as shown.
Use a small screwdriver to move the relay's connector clip down onto the rail, once it is in place.
Using the provided wiring, feed the two shrink-wrapped ends, and the brown wire, through the bottom of the electrical box, after removing an appropriate plastic grommet.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.