Mark the bed (REAR, FRONT, LEFT)
Obtain the M5x35mm screws from the bed attachment hardware bag.
Disconnect the four screws from the top of the bed plate, replace them with the M5x35mm screws, and secure with a small amount of tape.
Remove the bed and lay upside-down on a clean surface, taking careful note of which side is the LEFT SIDE of the bed. This is the side that the wires will protrude from.
Using brake parts cleaner or other non-residue cleaner, wipe down the bed of any dust, oil, or dirt.
With the protective plastic still installed on the bed, position the heated bad pad onto the metal bed, over the protruding screws.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.