Cut a small amount (1-2 inches) of the protective plastic away from the RIGHT edge of the heated bed.
Carefully affix the small strip of exposed adhesive to the metal bed, ensuring alignment with the corners, and screws still through the pre-drilled holes.
Remove the two screws closest to the affixed end.
Ensuring the affixed part of the bed stays stable, and lift up the remaining part of the heated pad, removing the plastic sheeting.
Carefully lay the bed back down, guiding the M5 screws through the pre-drilled holes.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.